description
standard active back-up ring for rod seal type PD. normally already included in PD type seal profiles, designed for automatic pressure activation. split and non split design available.
application
not bolded symbols; please consult our technical for application limitations
category of profile
machined only.
operating parameters & material
| material | temperature |
| POM | -50 °C … +100 °C |
| PA | -40 °C … +100 °C |
| PTFE glass | -200 °C … +260 °C |
the stated operation conditions represent general indications. it is recommended not to use all maximum values simultaneously. surface speed limits apply only to the presence of adequate lubrication film.
2 POM up to ø260 mm, PA above ø260 mm
seal & housing recommendations
please note that we are able to produce those profiles to your specific need or any non standard housing. for detail measurements, please see Jet seal pars catalog…
tolerance value and surface finish according to corresponding seal data sheet
don’t hesitate to contact our technical department for further information or for special requirements (temperature, speed etc.), so that suitable materi- als and/or designs can be recommended.