description

wiper with mounting cage for press-fit installation into axially open housings. wiping edge assures a reliable protection against penetration of dust and dirt, the use of plastic mounting cages avoids corrosion in the press-fit. for housings according ISO 6195-Type B.

 

 

 

  • the seal profile and close machining tolerances provide a good static seal for the outside diameter, assisting in the prevention of ingress of humidity and foreign matter via the trailing side.
  • the use of plastic for the retaining ring prevents corrosion in the seat.
  • an interference fit on the outside diameter ensures the wipers are held in place

and also prevent  humidity and foreign matter from entering via the outside

diameter.

  • this profile is not suited for pressure from the trailing side.

 

application

 

 

 

not bolded symbols; please consult our technical for application limitations

 

category of profile

machined or molded/standard/trade product.

 

single acting

 

operating parameters & material

the stated operation conditions represent general indications. it is recommended not to use all maximum  values simultaneously. surface speed limits apply only to the presence of adequate lubrication film.

 

 

surface quality

surface roughness

Ra (μm)

sliding surface according to seal data
bottom of groove ≤ 2.5
groove face ≤ 4.0

 

tolerance recommendation

seal housing tolerances
D H10

 

don’t hesitate to contact our technical department for further information or for special requirements (temperature, speed etc.), so that suitable materi- als and/or designs can be recommended.

 

 

 

www.jetseal-pars.com