description

wiper to fit in angled housings (30°angle). design mainly used in british equipment, in inch as well as metric dimensions.

 

  • no special holding systems are required for installa the rings snap into grooves and do not require a precision fit.
  • the design of the wiping edge aids recovery of the residual oil film; any dirt is wiped off reliably.
  • this design is used in english machines in particular and is common in both imperial and metric dimensions.
  • special housing designs required (angel on groove face= 30°).
  • pressure build-up on the trailing side is to be avoided if possible.

 

application

 

 

 

not bolded symbols; please consult our technical for application limitations

 

category of profile

machined only.

 

single acting

 

area of application: hydraulics

  • reciprocating rods on hydraulic cylinders.
  • push rods and valve stems.
  • (materials must be selected according to operating requirements).

 

function

WR04 wipers are designed to keep dust, dirt, sand and metal chips away from the sealing and guiding elements, thereby avoiding abra- sive damage caused by external contamination.

 

operating parameters & material

material

temperature

max. surface speed

hydrolysis

dry running

wear resistance

 PU

-30 °C ... +110 °C

4 m/s

-

+

++

 HPU

-20 °C ... +110 °C

4 m/s

++

+

++

LTPU

-50 °C ... +110 °C

4 m/s

-

+

++

 SPU

-20 °C ... +110 °C

5 m/s

++

++

++

GPU

-30 °C ... +110 °C

4 m/s

++

+

++

NBR

-30 °C ... +100 °C

4 m/s

-

-

O

FKM

-20 °C ... +200 °C

4 m/s

-

-

O

 EPDM2

-50 °C ... +150 °C

4 m/s

++

-

O

 HNBR

-25 °C ... +150 °C

4 m/s

+

O

+

 XPU

-30 °C ... +110 °C

4 m/s

 

 

 

HPU-D57

-20 °C ... +110 °C

4 m/s

 

 

 

SPU-D57

-20 °C ... +110 °C

5 m/s

 

 

 

the stated operation conditions represent general indications. it is recommended not to use all maximum values simultaneously. surface speed limits apply only to the presence of adequate lubrication film.

2 attention: not suitable for mineral oils!

++ ... particularly suitable                                    o ... conditional suitable

+ ... suitable                                                          - ... not suitable

for detailed information regarding chemical resistance please refer to our “list of resistance”. for increased chemical and thermal resistance rubber materials are to be preferred, polyurethan materials increase wear resistance.

 

surface quality

surface roughness

Rtmax (μm)

Ra (μm)

sliding surface according to seal data
bottom of groove ≤6,3 ≤1,6
groove face ≤15 ≤3

 

mode of installation

the prerequisites for perfect functioning are careful fitting and an accurately dimensioned mounting space. in general, wipers snap easily into their mountings when distorted into a kidney shape (over 20mm diameter).

 

seal & housing recommendations

please note that we are able to produce those profiles to your specific need or any non standard housing. for detail measurements, please see Jet seal pars catalog...

 

fitted:

 don’t hesitate to contact our technical department for further information or for special requirements (temperature, speed etc.), so that suitable materi- als and/or designs can be recommended.