description
wiper with interference fit on outside diameter. wiping edge assures a reliable protec- tion against penetration of dust and dirt whilst allowing backflow of residual oil film. back support area prevents tilting of wiper.
- the seal profile and close machining tolerances provide a good static seal for the outside diameter, assisting in the prevention of ingress of humidity and foreign matter via the outside diameter.
- the design of the wiping lip aids the recovery of residual oil film while exclusion of foreign matter is maintained.
- the provision of a support shoulder, along with relief grooves on the mating seal face, prevents tilting of the wiper and pressure build up on the trailing side.
- support shoulder not included in design WR 02-A
application
not bolded symbols; please consult our technical for application limitations
category of profile
machined or molded/standard/trade product.
single acting
area of application: hydraulics
- reciprocating rods on hydraulic cylinders.
- push rods and valve stems.
- (materials must be selected according to operating requirements).
- the WR 02-A design is to be used for mounting spaces according to ISO 6195-1986 type C.
function:
WR 02-A wipers are designed to keep dust, dirt, sand and metal chips away from the sealing and guiding elements, thereby avoid- ing abrasive damage caused by external contamination.
the stated operation conditions represent general indications. it is recommended not to use all maximum values simultaneously. surface speed limits apply only to the presence of adequate lubrication film.
surface quality
| surface roughness |
Rtmax (μm) |
Ra (μm) |
| sliding surface | according to seal data | |
| bottom of groove | ≤6,3 | ≤1,6 |
| groove face | ≤15 | ≤3 |
tolerance recommendation
| seal housing | tolerances |
| L < 10 mm | 0.2 |
| L ≥ 10 mm | 0.3 |
| D1 | H11 |
| D | H11 |
| cs | R [mm] |
| ≤ 5 | max. 0,3 |
| >5…….≤ 7,5 | max. 0,4 |
| >7,5….≤ 10 | max. 0,6 |
| > 10 | max. 0,8 |
mode of installation
the prerequisites for perfect functioning are careful fitting and an accurately dimensioned mounting space. in general, wipers snap easily into their housings when distorted into a kidney shape (over 20 mm diameter).
seal & housing recommendations
please note that we are able to produce those profiles to your specific need or any non standard housing. for detail measurements, please see jet seal pars catalog…
fitted:
don’t hesitate to contact our technical department for further information or for special requirements (temperature, speed etc.), so that suitable materi- als and/or designs can be recommended.