description
wiper with mounting cage for press-fit installation into axially open housings. wiping edge assures a reliable protection against penetration of dust and dirt, the use of plastic mounting cages avoids corrosion in the press-fit. for housings according ISO 6195-Type B.
- the seal profile and close machining tolerances provide a good static seal for the outside diameter, assisting in the prevention of ingress of humidity and foreign matter via the trailing side.
- the use of plastic for the retaining ring prevents corrosion in the seat.
- an interference fit on the outside diameter ensures the wipers are held in place
and also prevent humidity and foreign matter from entering via the outside
diameter.
- this profile is not suited for pressure from the trailing side.
application
not bolded symbols; please consult our technical for application limitations
category of profile
machined or molded/standard/trade product.
single acting
operating parameters & material
the stated operation conditions represent general indications. it is recommended not to use all maximum values simultaneously. surface speed limits apply only to the presence of adequate lubrication film.
surface quality
| surface roughness |
Ra (μm) |
| sliding surface | according to seal data |
| bottom of groove | ≤ 2.5 |
| groove face | ≤ 4.0 |
tolerance recommendation
| seal housing | tolerances |
| D | H10 |
don’t hesitate to contact our technical department for further information or for special requirements (temperature, speed etc.), so that suitable materi- als and/or designs can be recommended.