description
wiper seal with Polyamide (PA) material.
application
category of profile
machined or molded/standard/trade product.
single acting
operating parameters & material
the stated operation conditions represent general indications. it is recommended not to use all maximum values simultaneously. surface speed limits apply only to the presence of adequate lubrication film.
surface quality
| surface roughness | Ra (μm) |
| sliding surface | according to seal data |
| bottom of groove | ≤ 2.5 |
| groove face | ≤ 4.0 |
tolerance recommendation
| seal housing | tolerances |
| D | H10 |
don’t hesitate to contact our technical department for further information or for special requirements (temperature, speed etc.), so that suitable materi- als and/or designs can be recommended.