description

PTFE-double wiper with two O-rings as preloading elements. wiping edge assures a reliable protection against penetration of dust and dirt. additional sealing lip for reduction of residual oil film if used in combination with O-ring activated PTFE seals type S09 (tandem).  excellent chemical and thermal resistance (depends on O-ring ).

• the seal profile and close machining tolerances provide a good static seal for the outside diameter, assisting in the prevention of ingress of humidity and foreign matter via the outside diameter.
• the wiping part consists of PTFE with fillers, selected to suit the respective appli- cation, and two O-rings as preload elements. the PTFE part takes over the wiping function, the O-rings maintain even contact pressure.
• the design of the wiping edge aids recovery of the residual oil film; any dirt is wiped off reliably.
• in addition, the sealing edge reduces the residual oil film on the side of the me- dium if composite seals on PTFE basis, (e.g. S09), are used (tandem arrangement). in the standard design, pressurisation should be limited to 16 bar.

application

not bolded symbols; please consult our technical for application limitations

category of profile

machined or molded/standard/trade product.

double acting

• the seal profile and close machining tolerances provide a good static seal for the outside diameter, assisting in the prevention of ingress of humidity and foreign matter via the outside diameter.
• the wiping part consists of PTFE with fillers, selected to suit the respective appli- cation, and two O-rings as preload elements. the PTFE part takes over the wiping function, the O-rings maintain even contact pressure.
• the design of the wiping edge aids recovery of the residual oil film; any dirt is wiped off reliably.
• in addition, the sealing edge reduces the residual oil film on the side of the me- dium if composite seals on PTFE basis, (e.g. S09), are used (tandem arrangement). in the standard design, pressurisation should be limited to 16 bar.

area of application: hydraulics/pneumatics

• reciprocating, swivelling and coiling rods on hydraulic cylinders.
• push rods and valve stems.
• (materials must be selected according to operating requirements).
• industrial vehicles, injection moulding machines, handling equipment, presses, agricultural machinery, mills, control and regulation equipment, large cylinders.

function:

WR 15 wipers are designed to keep dust, dirt, sand and metal chips from the sealing and guiding elements, thereby avoiding abrasive dam- age caused by external contamination.

for detailed information regarding chemical resistance please refer to our “list of resistance”.

surface quality

tolerance recommendation

mode of installation

the prerequisites for perfect functioning are careful fitting and an accurately dimensioned mounting space. in general, wipers snap easily into their housings when distorted into a kidney shape (over 20mm diameter). a large insertion chamfer must be provided (20-30°, length = (D-d)/4).

seal & housing recommendations

please note that we are able to produce those profiles to your specific need or any non standard housing. for detail measurements, please see jet seal pars catalog…

fitted:

don’t hesitate to contact our technical department for further information or for special requirements (temperature, speed etc.), so that suitable materi- als and/or designs can be recommended.